HP FlexNetwork HSR6600 Configuration Manual page 143

Tunnel source unknown, destination 4.4.4.9
Tunnel TTL 255
Tunnel protocol/transport CR_LSP
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
# Display detailed information about the MPLS TE tunnel on Router A.
[RouterA] display mpls te tunnel-interface
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
Backup Bandwidth Flag: Disabled
Backup Bandwidth
Bypass Tunnel
Route Pinning
Retry Limit
Reoptimization
Backup Type
Auto Bandwidth
Min Bandwidth
Collected Bandwidth
# Display detailed information about the bidirectional MPLS TE tunnel on Router A.
[RouterA] display mpls lsp verbose
Destination : 4.4.4.9
FEC : 1.1.1.9/1/30478
Protocol : RSVP
LSR Type : Ingress
Service : -
NHLFE ID : 1027
: Tunnel 1
: Up (Main CRLSP up, Reverse CRLSP up)
:
: 30478 Tunnel ID
: Normal
: 1.1.1.9 Egress LSR ID
: RSVP-TE Static CRLSP Name
: FF
: Co-routed, active
: -
: - Reverse-LSP Tunnel ID: -
: CT0 Tunnel Bandwidth
: 0 kbps
: 7 Holding Priority
: 0/0
: -
: TE
: Disabled Record Label
: Disabled Bandwidth Protection : Disabled
Backup Bandwidth Type: -
: -
: No Auto Created
: Disabled
: 10 Retry Interval
: Disabled Reoptimization Freq
: None Backup LSP ID
: Disabled Auto Bandwidth Freq
: - Max Bandwidth
: -
133
: 1
: 4.4.4.9
: -
: 0 kbps
: 7
: Disabled
: No
: 2 sec
: -
: -
: -
: -