Ietf Ds-Te Configuration Example - HP FlexNetwork HSR6600 Configuration Manual

2.2.2.1/1/16802
Backup
2.2.2.2/50/16802
3.2.1.2
3.3.1.2
# Display detailed information about MPLS TE tunnel 1 (the tunnel for the primary CRLSP) on Router
B. The output shows that Tunnel1 is protected by the bypass tunnel Tunnel50, and the protected
node is 3.1.1.1.
[RouterB] display rsvp lsp tunnel-id 1 verbose
Tunnel name: Tunnel1
Destination: 4.4.4.4
Tunnel ID: 1
LSR type: Transit
Setup priority: 7
In-Label: 1150
In-Interface: GE1/1/1
Nexthop: 3.1.1.2
Include-Any: 0
Average bitrate: 0 kbps
Path MTU: 1500
RRO number: 12
2.1.1.1/32
2.1.1.2/32
1150
2.2.2.2/32
3.1.1.1/32
3.1.1.2/32
1151
3.3.3.3/32
4.1.1.1/32
4.1.1.2/32
3
4.4.4.4/32
Fast Reroute protection: Ready
FRR inner label: 3

IETF DS-TE configuration example

Network requirements
Router A, Router B, Router C, and Router D run IS-IS and all of them are Level-2 routers.
Use RSVP-TE to establish an MPLS TE tunnel from Router A to Router D to transmit data between
the two IP networks. Traffic of the tunnel belongs to CT 2, and the tunnel needs a bandwidth of 4000
kbps.
The maximum bandwidth of the link that the tunnel traverses is 10000 kbps and the maximum
reservable bandwidth of the link is 10000 kbps. BC 1, BC 2, and BC 3 are 8000 kbps, 5000 kbps, and
2000 kbps.
RSVP -/1151
-/3
RSVP -/3
Local -/-
Local -/-
Flag: 0x00 (No FRR)
Flag: 0x00 (No FRR)
Flag: 0x01 (Global label)
Flag: 0x20 (No FRR/Node-ID)
Flag: 0x09 (FRR Avail/Node-Prot)
Flag: 0x00 (No FRR)
Flag: 0x01 (Global label)
Flag: 0x20 (No FRR/Node-ID)
Flag: 0x00 (No FRR)
Flag: 0x00 (No FRR)
Flag: 0x01 (Global label)
Flag: 0x20 (No FRR/Node-ID)
Bypass tunnel: Tunnel50
151
GE1/1/2
Tun50
POS1/1/1
POS1/1/1
POS1/1/0
Source: 1.1.1.1
LSP ID: 16802
Direction: Unidirectional
Holding priority: 7
Out-Label: 1151
Out-Interface: GE1/1/2
Exclude-any: 0
Include-all: 0
Maximum burst: 1000.00 bytes
Class type: CT0