HP FlexNetwork HSR6600 Configuration Manual page 169

Figure 42 Network diagram
Table 10 Interface and IP address assignment
Device
Router A
Router B
Router C
Configuration procedure
1. Configure IP addresses and masks for interfaces, including the loopback interfaces, as shown
in Table
2. Configure IS-IS to advertise interface addresses including loopback interface addresses, and
configure IS-IS TE. (Details not shown.)
3. Configure an LSR ID, and enable MPLS, MPLS TE, and RSVP-TE on each router. (Details not
shown.)
Interface IP address
Loop0 1.1.1.1/32
GE1/1/1 10.1.1.1/24
GE1/1/2 20.1.1.1/24
GE1/1/3 30.1.1.1/24
GE1/1/4 100.1.1.1/24
Loop0 2.2.2.2/32
GE1/1/1 10.1.1.2/24
GE1/1/2 100.1.1.1/24
Loop0 3.3.3.3/32
GE1/1/1 20.1.1.2/24
GE1/1/2 200.1.1.1/24
10. (Details not shown.)
Device Interface
Router D Loop0
GE1/1/1
GE1/1/2
Router E Loop0
GE1/1/1
GE1/1/2
GE1/1/3
159
IP address
4.4.4.4/32
30.1.1.2/24
40.1.1.1/24
5.5.5.5/32
100.1.1.2/24
200.1.1.2/24
40.1.1.1.2/24