Bidirectional Mpls Te Tunnel - HP FlexNetwork HSR6600 Configuration Manual

− The total bandwidth occupied by CT 0, CT 1, and CT 2 cannot exceed the maximum
Figure 31 MAM bandwidth constraints model
CT 2
CT 0
3. Verifies that the CT and the LSP setup/holding priority match an existing TE class.
An MPLS TE tunnel can be established for the CT only when the following conditions are met:
Every node along the tunnel has a TE class that matches the CT and the LSP setup priority.
Every node along the tunnel has a TE class that matches the CT and the LSP holding
priority.

Bidirectional MPLS TE tunnel

MPLS Transport Profile (MPLS-TP) uses bidirectional MPLS TE tunnels to implement 1:1 and 1+1
protection switching, and to support in-band detection tools and signaling protocols such as OAM
and PSC.
A bidirectional MPLS TE tunnel includes a pair of CRLSPs in opposite directions. It can be
established in the following modes:
•
Co-routed mode—Uses the extended RSVP-TE protocol to establish a bidirectional MPLS TE
tunnel. RSVP-TE uses a Path message to advertise the labels assigned by the upstream LSR
to the downstream LSR. RSVP-TE uses a Resv message to advertise the labels assigned by
the downstream LSR to the upstream LSR. During the delivery of the path message, a CRLSP
in one direction is established. During the delivery of the Resv message, a CRLSP in the other
direction is established. The CRLSPs of a bidirectional MPLS TE tunnel established in
co-routed mode use the same path.
•
Associated mode—In this mode, you establish a bidirectional MPLS TE tunnel by binding two
unidirectional CRLSPs in opposite directions. The two CRLSPs can be established in different
modes and use different paths. For example, one CRLSP is established statically and the other
CRLSP is established dynamically by RSVP-TE.
For more information about establishing MPLS TE tunnel through RSVP-TE, the Path message, and
the Resv message, see "Configuring RSVP."
CBTS
About CBTS
Class-of-service Based Tunnel Selection (CBTS) enables dynamic routing and forwarding of traffic
with different class of service (CoS) values over different MPLS TE tunnels between the same tunnel
headend and tailend. Unlike load sharing that selects multiple tunnels to forward the matching traffic,
CBTS uses a dedicated tunnel for a certain class of service.
reservable bandwidth.
CT 0
BC 0
CT 1
BC 1
BC 2
CT 1 CT 2
Max reservable BW
80