HP FlexNetwork HSR6600 Configuration Manual page 38
Comware 7 mpls
Hide thumbs
Also See for FlexNetwork HSR6600:
- Command reference manual (542 pages) ,
- Troubleshooting manual (41 pages) ,
- Security configuration manual (559 pages)
Table of Contents
Advertisement
Step
4.
Set the Keepalive interval.
5.
Configure the LDP transport
address.
Configuring LDP IPv4 sessions parameters for Extended Discovery mechanism
Step
1.
Enter system view.
2.
Enter LDP view.
3.
Specify an IPv4 LDP peer and
enter LDP peer view. The
device will send unsolicited
IPv4 Targeted Hellos to the
peer and can respond to IPv4
Targeted Hellos received from
the targeted peer.
4.
Set the Keepalive hold time.
5.
Set the Keepalive interval.
6.
Configure the LDP transport
address.
Configuring LDP IPv6 sessions parameters for Extended Discovery mechanism
Step
1.
Enter system view.
2.
Enter LDP view.
3.
Specify an IPv6 LDP peer and
enter LDP peer view. The
device will send unsolicited
IPv6 Targeted Hellos to the
peer and can respond to IPv6
Targeted Hellos received from
the targeted IPv6 peer.
4.
Set the Keepalive hold time.
Command
mpls ldp timer
keepalive-interval interval
mpls ldp transport-address
{ ipv4-address | ipv6-address |
interface }
Command
system-view
mpls ldp
targeted-peer ipv4-address
mpls ldp timer keepalive-hold
timeout
mpls ldp timer
keepalive-interval interval
mpls ldp transport-address
ipv4-address
Command
system-view
mpls ldp
targeted-peer ipv6-address
mpls ldp timer keepalive-hold
timeout
28
Remarks
By default, the Keepalive interval
is 15 seconds.
By default, the LDP transport
address is the LSR ID of the local
device if the interface where you
want to establish an LDP session
belongs to the public network. If
the interface belongs to a VPN,
the LDP transport address is the
primary IP address of the
interface.
If the interface where you want to
establish an LDP session is
bound to a VPN instance, the
interface with the IP address
specified with this command must
be bound to the same VPN
instance.
Remarks
N/A
N/A
By default, the device does not
send IPv4 Targeted Hellos to
any peers, or respond to IPv4
Targeted Hellos received from
any peers.
By default, the Keepalive hold
time is 45 seconds.
By default, the Keepalive
interval is 15 seconds.
By default, the LDP transport
address is the LSR ID of the
local device.
Remarks
N/A
N/A
By default, the device does not
send IPv6 Targeted Hellos to
any peers, or respond to IPv6
Targeted Hellos received from
any peers.
By default, the Keepalive hold
time is 45 seconds.
Advertisement
Table of Contents
