HP FlexNetwork HSR6600 Configuration Manual page 131

[RouterC-bgp-ipv4] peer 20.1.1.1 enable
[RouterC-bgp-ipv4] import-route ospf
[RouterC-bgp-ipv4] import-route direct
[RouterC-bgp-ipv4] quit
[RouterC-bgp] quit
# Verify that the routers have learned the AS-external routes. This example uses Router A.
[RouterA] display ip routing-table
Destinations : 10
Destination/Mask
1.1.1.9/32
2.2.2.9/32
3.3.3.9/32
4.4.4.9/32
10.1.1.0/24
10.1.1.1/32
20.1.1.0/24
30.1.1.0/24
127.0.0.0/8
127.0.0.1/32
4. Configure an LSR ID, and enable MPLS, MPLS TE, and RSVP-TE:
# Configure Router A.
[RouterA] mpls lsr-id 1.1.1.9
[RouterA] mpls te
[RouterA-te] quit
[RouterA] rsvp
[RouterA-rsvp] quit
[RouterA] interface gigabitethernet 1/1/1
[RouterA-GigabitEthernet1/1/1] mpls enable
[RouterA-GigabitEthernet1/1/1] mpls te enable
[RouterA-GigabitEthernet1/1/1] rsvp enable
[RouterA-GigabitEthernet1/1/1] quit
# Configure Router B.
[RouterB] mpls lsr-id 2.2.2.9
[RouterB] mpls te
[RouterB-te] quit
[RouterB] rsvp
[RouterB-rsvp] quit
[RouterB] interface gigabitethernet 1/1/1
[RouterB-GigabitEthernet1/1/1] mpls enable
[RouterB-GigabitEthernet1/1/1] mpls te enable
[RouterB-GigabitEthernet1/1/1] rsvp enable
[RouterB-GigabitEthernet1/1/1] quit
[RouterB] interface pos 1/1/0
[RouterB-POS1/1/0] mpls enable
[RouterB-POS1/1/0] mpls te enable
[RouterB-POS1/1/0] rsvp enable
Routes : 10
Proto Pre Cost
Direct 0 0
O_INTRA 10 1
O_ASE 150 1
O_ASE 150 1
Direct 0 0
Direct 0 0
O_ASE 150 1
O_ASE 150 1
Direct 0 0
Direct 0 0
121
NextHop Interface
127.0.0.1 InLoop0
10.1.1.2 GE1/1/1
10.1.1.2 GE1/1/1
10.1.1.2 GE1/1/1
10.1.1.1 GE1/1/1
127.0.0.1 InLoop0
10.1.1.2 GE1/1/1
10.1.1.2 GE1/1/1
127.0.0.1 InLoop0
127.0.0.1 InLoop0