Configuring A Bgp Auto-Discovery Ldp Pw - HP FlexNetwork HSR6600 Configuration Manual

Step
6. (Optional.) Specify a PW
class for the auto-discovery
VSI.
7. (Optional.) Specify a tunnel
policy for the auto-discovery
VSI.
8. Use BGP to create a PW to
an automatically discovered
remote PE and enter
auto-discovery VSI BGP
signaling view.
9. Create a local site.

Configuring a BGP auto-discovery LDP PW

Before you perform this configuration, enable MPLS LDP on interfaces and globally. For more
information, see "Configuring LDP."
To configure a BGP auto-discovery LDP PW, perform the following configurations on PEs:
•
Configure BGP to advertise VPLS PE information.
•
Use LDP to create a PW.
Configuring BGP to advertise VPLS PE information
Step
1. Enter system view.
2. Enable BGP instance and
enter BGP instance view.
3. Configure the remote PE as a
BGP peer.
4. Create the BGP L2VPN
address family and enter BGP
L2VPN address family view.
5. Enable BGP to exchange
VPLS PE information with the
specified peer or peer group.
6. Enable BGP to exchange
VPLS PE information with the
specified peer or peer group.
7. (Optional.) Permit the local
AS number to appear in
routes from the specified peer
or peer group and specify the
appearance times.
8. (Optional.) Enable route
target-based filtering of
incoming BGP L2VPN
information.
Command
pw-class class-name
tunnel-policy tunnel-policy-name
signaling-protocol bgp
site site-id [ range range-value ]
[ default-offset default-offset ]
Command
system-view
bgp as-number [ instance
instance-name ]
peer { group-name | ip-address
[ mask-length ] } as-number
as-number
address-family l2vpn
peer { group-name | ip-address
[ mask-length ] } enable
peer { group-name | ip-address
[ mask-length ] }
auto-discovery
[ non-standard ]
peer { group-name | ip-address
[ mask-length ] } allow-as-loop
[ number ]
policy vpn-target
450
Remarks
By default, no PW class is
specified.
By default, no tunnel policy is
specified.
By default, no signaling protocol is
specified.
By default, no local sites exist.
Remarks
N/A
By default, BGP is disabled.
By default, no BGP peers exist.
By default, no BGP L2VPN address
family exists.
By default, BGP cannot exchange
VPLS PE information with a peer or
peer group.
By default, BGP can exchange
VPLS PE information with a BGP
L2VPN peer or peer group by using
RFC 6074 MP_REACH_NLRI.
By default, the local AS number is
not allowed in routes from a peer or
peer group.
By default, route target-based
filtering of incoming BGP L2VPN
information is enabled.