Configuring Mpls L3Vpn Carrier's Carrier In The Same As - HP FlexNetwork HSR6600 Configuration Manual

[CE2-GigabitEthernet1/1/1] ip address 20.0.0.2 24
[CE2-GigabitEthernet1/1/1] quit
# Establish an EBGP peer relationship with PE 2, and redistribute VPN routes.
[CE2] bgp 65002
[CE2-bgp-default] peer 20.0.0.1 as-number 600
[CE2-bgp-default] address-family ipv4 unicast
[CE2-bgp-default-ipv4] peer 20.0.0.1 enable
[CE2-bgp-default-ipv4] import-route direct
[CE2-bgp-default-ipv4] quit
[CE2-bgp-default] quit
Verifying the configuration
# Execute the display ip routing table command on CE 1 and CE 2 to verify that CE 1 and CE 2
have a route to each other. Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring MPLS L3VPN carrier's carrier in the same AS

Network requirements
Configure carrier's carrier for the scenario shown in
•
PE 1 and PE 2 are the provider carrier's PE routers. They provide VPN services for the
customer carrier.
•
CE 1 and CE 2 are the customer carrier's routers. They are connected to the provider carrier's
backbone as CE routers.
•
PE 3 and PE 4 are the customer carrier's PE routers. They provide MPLS L3VPN services for
the end customers.
•
CE 3 and CE 4 are customers of the customer carrier.
•
The customer carrier and the provider carrier reside in the same AS.
The key to carrier's carrier deployment is to configure exchange of two kinds of routes:
•
Exchange of the customer carrier's internal routes on the provider carrier's backbone.
•
Exchange of the end customers' VPN routes between PE 3 and PE 4, the PEs of the customer
carrier. In this process, an MP-IBGP peer relationship must be established between PE 3 and
PE 4.
Figure 77. In this scenario:
272