H-Vpls Upe Dual Homing Configuration Example - HP FlexNetwork HSR6600 Configuration Manual

Link ID
In Label
MTU
PW Attributes
VCCV CC
VCCV BFD
Tunnel Group ID
Tunnel NHLFE IDs
Peer: 3.3.3.9
Signaling Protocol
Link ID
In Label
MTU
PW Attributes
VCCV CC
VCCV BFD
Tunnel Group ID
Tunnel NHLFE IDs

H-VPLS UPE dual homing configuration example

Network requirements
To improve reliability of the H-VPLS network, the UPE establishes a U-PW with NPE 1 and NPE 2.
The U-PW between UPE and NPE 1 is the primary PW and that between UPE and NPE 2 is the
backup PW. The backup PW works only when the primary PW fails.
The H-VPLS uses LDP as the PW signaling protocol.
Figure 128 Network diagram
Configuration procedure
1. Configure an IGP and public tunnels on each PE. (Details not shown.)
: 8 PW State : Up
: 1279 Out Label: 1278
: 1500
: Main
: -
: -
: 0x660000000
: 1031
PW ID: 500
: LDP
: 9 PW State : Up
: 1277 Out Label: 1277
: 1500
: Main
: -
: -
: 0x670000000
: 1032
475