Configuring A Bgp Pw - HP FlexNetwork HSR6600 Configuration Manual

[PE2] display l2vpn pw
Flags: M - main, B - backup, BY - bypass, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1
1 up, 0 blocked, 0 down, 0 defect, 0 idle, 0 duplicate
Xconnect-group Name: vpna
Peer
192.2.2.2
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring a BGP PW

Network requirements
Create a BGP PW between PE 1 and PE 2 to allow communication between CE 1 and CE 2.
Figure 113 Network diagram
Table 42 Interface and IP address assignment
Device
CE 1
PE 1
CE 2
Configuration procedure
1. Configure CE 1.
<CE1> system-view
[CE1] interface gigabitethernet 1/1/1
[CE1-GigabitEthernet1/1/1] ip address 100.1.1.1 24
[CE1-GigabitEthernet1/1/1] quit
2. Configure PE 1:
# Configure an LSR ID.
PW ID/Rmt Site
3
Interface IP address
GE1/1/1 100.1.1.1/24
Loop0 192.2.2.2/32
GE1/1/1 -
GE1/1/2 10.1.1.1/24
GE1/1/1 100.1.1.2/24
In/Out Label Proto
1279/1279 LDP
Device
P
PE 2
422
Flag Link ID
M 1
Interface IP address
Loop0 192.4.4.4/32
GE1/1/1 10.1.1.2/24
GE1/1/2 10.2.2.2/24
Loop0 192.3.3.3/32
GE1/1/1 -
GE1/1/2 10.2.2.1/24
State
Up