Qppb Configuration Example In An Ipv6 Network - HP FlexNetwork MSR Series Configuration Manuals

Direction: Outbound
Policy: qppb
Classifier: default-class
Matched : 311 (Packets) 23243 (Bytes)
5-minute statistics:
Forwarded: 0/24 (pps/bps)
Dropped
Operator: AND
Rule(s) :
If-match any
Behavior: be
-none-
Classifier: qppb
Matched : 0 (Packets) 0 (Bytes)
5-minute statistics:
Forwarded: 0/0 (pps/bps)
Dropped
Operator: AND
Rule(s) :
If-match qos-local-id 1023
Behavior: qppb
Committed Access Rate:
CIR 2000 (kbps), CBS 125000 (Bytes), EBS 512 (Bytes)
Green action
Yellow action : pass
Red action
Green packets : 0 (Packets) 0 (Bytes)
Yellow packets: 0 (Packets) 0 (Bytes)
Red packets

QPPB configuration example in an IPv6 network

Network requirements
As shown in
Configure QPPB so that Router B can perform the following operations:
•
Receive routes.
•
Set the QPPB IP precedence value.
•
Use the QoS policy to limit the rate of traffic with the IP precedence value to 512 kbps.
: 0/0 (pps/bps)
: 0/0 (pps/bps)
: pass
: discard
: 0 (Packets) 0 (Bytes)
Figure 29, all routers run BGP.
108