HP FlexNetwork HSR6600 Configuration Manual page 473

Comware 7 mpls

Hide thumbs Also See for FlexNetwork HSR6600:

Table of Contents

Figure 125 Network diagram

Configuration procedure

Configure an IGP and public tunnels on each PE. (Details not shown.)

Configure PE 1:

# Configure basic MPLS.

<PE1> system-view

[PE1] interface loopback 0

[PE1-LoopBack0] ip address 1.1.1.9 32

[PE1-LoopBack0] quit

[PE1] mpls lsr-id 1.1.1.9

[PE1] mpls ldp

[PE1-ldp] quit

# Establish IBGP connections to PE 2 and PE 3, and use BGP to advertise VPLS label block

information.

[PE1] bgp 100

[PE1-bgp-default] peer 2.2.2.9 as-number 100

[PE1-bgp-default] peer 2.2.2.9 connect-interface loopback 0

[PE1-bgp-default] peer 3.3.3.9 as-number 100

[PE1-bgp-default] peer 3.3.3.9 connect-interface loopback 0

[PE1-bgp-default] address-family l2vpn

[PE1-bgp-default-l2vpn] peer 2.2.2.9 enable

[PE1-bgp-default-l2vpn] peer 3.3.3.9 enable

[PE1-bgp-default-l2vpn] quit

[PE1-bgp-default] quit

# Enable L2VPN.

[PE1] l2vpn enable

# Configure VSI aaa to use BGP to establish BGP PWs to PE 2 and PE 3.

[PE1] vsi aaa

[PE1-vsi-aaa] auto-discovery bgp

[PE1-vsi-aaa-auto] route-distinguisher 1:1

[PE1-vsi-aaa-auto] vpn-target 1:1

[PE1-vsi-aaa-auto] signaling-protocol bgp

[PE1-vsi-aaa-auto-bgp] site 1 range 10 default-offset 0