HP FlexNetwork HSR6600 Configuration Manual page 123

The maximum bandwidth of the link that the tunnel traverses is 10000 kbps and the maximum
reservable bandwidth of the link is 5000 kbps.
Figure 34 Network diagram
Table 3 Interface and IP address assignment
Device
Router A
Router B
Configuration procedure
1. Configure IP addresses and masks for interfaces. (Details not shown.)
2. Configure IS-IS to advertise interface addresses, including the loopback interface address:
# Configure Router A.
<RouterA> system-view
[RouterA] isis 1
[RouterA-isis-1] network-entity 00.0005.0000.0000.0001.00
[RouterA-isis-1] quit
[RouterA] interface gigabitethernet 1/1/1
[RouterA-GigabitEthernet1/1/1] isis enable 1
[RouterA-GigabitEthernet1/1/1] isis circuit-level level-2
[RouterA-GigabitEthernet1/1/1] quit
[RouterA] interface loopback 0
[RouterA-LoopBack0] isis enable 1
[RouterA-LoopBack0] isis circuit-level level-2
[RouterA-LoopBack0] quit
# Configure Router B.
<RouterB> system-view
[RouterB] isis 1
Interface IP address
Loop0 1.1.1.9/32
GE1/1/1 10.1.1.1/24
GE1/1/2 100.1.1.1/24
Loop0 2.2.2.9/32
GE1/1/1 10.1.1.2/24
POS1/1/0 20.1.1.1/24
Device Interface
Router C Loop0
GE1/1/1
POS1/1/0
Router D Loop0
GE1/1/1
GE1/1/2
113
IP address
3.3.3.9/32
30.1.1.1/24
20.1.1.2/24
4.4.4.9/32
30.1.1.2/24
100.1.2.1/24