Register-Policy (Ipv6 Pim View) - HP 3600 v2 Series Command Reference Manual

Default level
2: System level
Parameters
interval: Prune delay time in the range of 1 to 128 seconds.
Description
Use prune delay to configure the prune delay time, namely, the length of time that the device waits
between receiving a prune message and taking a prune action.
Use undo prune delay to restore the default.
By default, the prune delay time is not configured.
Examples
# Set the prune delay time to 75 seconds in the public network.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] prune delay 75

register-policy (IPv6 PIM view)

Syntax
register-policy acl6-number
undo register-policy
View
IPv6 PIM view
Default level
2: System level
Parameters
acl6-number: Advanced IPv6 ACL number, in the range of 3000 to 3999. The RP can accept only
register messages that match the permit statement of the IPv6 ACL.
Description
Use register-policy to configure an IPv6 ACL rule to filter register messages.
Use undo register-policy to remove the configured register filtering rule.
By default, no register filtering rule is configured.
Related commands: register-suppression-timeout.
Examples
# Configure a register filtering policy on the RP so that the RP accepts only those register messages from
IPv6 multicast sources on the 3:1::/64 subnet for IPv6 multicast groups on the FF0E:13::/64 subnet.
<Sysname> system-view
[Sysname] acl ipv6 number 3000
[Sysname-acl6-adv-3000] rule permit ipv6 source 3:1:: 64 destination ff0e:13:: 64
[Sysname-acl6-adv-3000] quit
[Sysname] pim ipv6
396