Pim Configuration Commands (Available Only On The Hp 3600 V2 Ei); Auto-Rp Enable - HP 3600 v2 Series Command Reference Manual
Ip multicast
Hide thumbs
Also See for 3600 v2 Series:
- Command reference manual (510 pages) ,
- Configuration manual (449 pages) ,
- Security configuration manual (398 pages)
Table of Contents
Advertisement
PIM configuration commands (available only
on the HP 3600 v2 EI)
The term "router" in this document refers to both routers and Layer 3 switches.
The term "interface" in this chapter collectively refers to Layer 3 interfaces, including VLAN and Layer 3
Ethernet interfaces. You can set an Ethernet port as a Layer 3 interface by using the port link-mode route
command (see Layer 2—LAN Switching Configuration Guide).
auto-rp enable
Syntax
auto-rp enable
undo auto-rp enable
View
Public network PIM view, VPN instance PIM view
Default level
2: System level
Parameters
None
Description
Use auto-rp enable to enable auto-RP.
Use undo auto-rp enable to disable auto-RP.
By default, auto-RP is disabled.
Related commands: static-rp.
Examples
# Enable auto-RP in the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] auto-rp enable
# Enable auto-RP in VPN instance mvpn.
<Sysname> system-view
[Sysname] pim vpn-instance mvpn
[Sysname-pim-mvpn] auto-rp enable
113
Advertisement
Table of Contents
