Display Multicast Ipv6 Routing-Table - HP 3600 v2 Series Command Reference Manual

Field
Total 1 RP matched
00001
MID
Flags
Uptime
RPF interface
List of 1 DF interfaces

display multicast ipv6 routing-table

Syntax
display multicast ipv6 routing-table [ ipv6-source-address [ prefix-length ] | ipv6-group-address
[ prefix-length ] | incoming-interface { interface-type interface-number | register } | outgoing-interface
{ exclude | include | match } { interface-type interface-number | register } ] * [ | { begin | exclude |
include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
ipv6-source-address: Specifies a multicast source address.
ipv6-group-address: Specifies an IPv6 multicast group address, in the range of FFxy::/16, where x and
y represent any hexadecimal number from 0 through F.
prefix-length: Specifies the length of the prefix of a multicast group address or an IPv6 multicast source
address. For an IPv6 multicast group address, the value ranges from 8 to 128. For an IPv6 multicast
source address, the value ranges from 0 to 128. The default is 128 in both cases.
incoming-interface: Displays routing entries whose incoming interface is the specified one.
interface-type interface-number: Specifies an interface by its type and number.
register: Represents a registered interface.
outgoing-interface: Displays routing entries whose the outgoing interface is the specified one.
exclude: Displays routing entries whose outgoing interface list excludes the specified interface.
include: Displays routing entries whose outgoing interface list includes the specified interface.
match: Displays routing entries whose outgoing interface list includes only the specified interface.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
Description
Total number of matched RPs.
Sequence number of the RP.
ID of the RP. Each RP has a unique MID.
Current state of the RP. Different bits indicate different states of an RP.
Major values of the flags field before the colon are described in
64. The value of the flags field after the colon is 0.
Length of time for which the RP has been up, in the format
hours:minutes:seconds.
RPF interface to the RP.
DF interface list.
303
Table