Last-Member-Query-Interval (Igmp-Snooping View); Mac-Address Multicast - HP 3600 v2 Series Command Reference Manual

<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3

last-member-query-interval (IGMP-snooping view)

Syntax
last-member-query-interval interval
undo last-member-query-interval
View
IGMP-snooping view
Default level
2: System level
Parameters
interval: Specifies the IGMP last-member query interval in seconds. The value ranges from 1 to 5.
Description
Use last-member-query-interval to set the IGMP last-member query interval globally.
Use undo last-member-query-interval to restore the default.
By default, the IGMP last-member query interval is 1 second.
The IGMP last-member query interval determines the interval for sending IGMP group-specific queries
and the maximum response delay for IGMP group-specific queries.
This command takes effect only in IGMP snooping-enabled VLANs.
Related commands: igmp-snooping last-member-query-interval.
Examples
# Set the IGMP last-member query interval to 3 seconds globally.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] last-member-query-interval 3

mac-address multicast

Syntax
In system view:
mac-address multicast mac-address interface interface-list vlan vlan-id
undo mac-address [ multicast ] [ [ mac-address [ interface interface-list ] ] vlan vlan-id ]
In Ethernet interface view or Layer 2 aggregate interface view:
mac-address multicast mac-address vlan vlan-id
32