Peer Advertise-Community (Mbgp Address Family View) - HP 3600 v2 Series Command Reference Manual

short-cut: Specifies the route to use the local preference. If the route is an eBGP route whose preference
is higher than the local preference, using this keyword can configure the eBGP route to use the local
preference, and thus the route cannot become the optimal route.
route-policy-name: Specifies the routing policy applied to the route. The name is a case-sensitive string of
1 to 63 characters.
Description
Use network to inject a network to the IPv4 MBGP routing table.
Use undo network to remove a network from the IPv4 MBGP routing table.
By default, no network route is injected.
The network route to be injected must exist in the local IP routing table, and using a routing policy makes
route management more flexible.
The ORIGIN attribute of the network route injected through the network command is IGP.
Examples
# In IPv4 MBGP address family view, inject the network 10.0.0.0/16.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family multicast
[Sysname-bgp-af-mul] network 10.0.0.0 255.255.0.0

peer advertise-community (MBGP address family view)

Syntax
peer { group-name | ip-address } advertise-community
undo peer { group-name | ip-address } advertise-community
View
IPv4 MBGP address family view
Default level
2: System level
Parameters
group-name: Specifies an IPv4 MBGP peer group by its name, a string of 1 to 47 characters.
ip-address: Specifies an IPv4 MBGP peer by its IP address.
Description
Use peer advertise-community to advertise the COMMUNITY attribute to a peer or a peer group.
Use undo peer advertise-community to disable the COMMUNITY attribute advertisement to a peer or a
peer group.
By default, no COMMUNITY attribute is advertised to any peer or peer group.
Related commands: apply community, if-match community, and ip community-list (Layer 3—IP Routing
Command Reference).
234