Peer Reflect-Client (Ipv6 Mbgp Address Family View); Peer Route-Limit (Ipv6 Mbgp Address Family View) - HP 3600 v2 Series Command Reference Manual

peer reflect-client (IPv6 MBGP address family view)

Syntax
peer { ipv6-group-name | ipv6-address } reflect-client
undo peer { ipv6-group-name | ipv6-address } reflect-client
View
IPv6 MBGP address family view
Default level
2: System level
Parameters
ipv6-group-name: Specifies an IPv6 MBGP peer group by its name, a string of 1 to 47 characters.
ipv6-address: Specifies an IPv6 MBGP peer by its IP address.
Description
Use peer reflect-client to configure the router as a route reflector and specify an IPv6 MBGP peer or a
peer group as its client.
Use undo peer reflect-client to remove the configuration.
By default, neither route reflector nor client is configured.
Related commands: reflect between-clients and reflector cluster-id.
Examples
# Configure the local device as a route reflector and specify the peer group test as a client.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test internal
[Sysname-bgp-af-ipv6] quit
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] peer test enable
[Sysname-bgp-af-ipv6-mul] peer test reflect-client

peer route-limit (IPv6 MBGP address family view)

Syntax
peer { ipv6-group-name | ipv6-address } route-limit limit [ percentage ]
undo peer { ipv6-group-name | ipv6-address } route-limit
View
IPv6 MBGP address family view
Default level
2: System level
Parameters
ipv6-group-name: Specifies an IPv6 MBGP peer group by its name, a string of 1 to 47 characters.
449