Mld Static-Group - HP 3600 v2 Series Command Reference Manual

Parameters
interval: Specifies a startup query interval in seconds, namely, the interval between general queries that
the MLD querier sends on startup, in the range of 1 to 18000.
Description
Use mld startup-query-interval to configure the startup query interval on the current interface.
Use undo mld startup-query-interval to restore the default.
By default, the startup query interval is 1/4 of the MLD query interval.
Related commands: mld timer query and startup-query-interval.
Examples
# Set the startup query interval to 5 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld startup-query-interval 5

mld static-group

Syntax
mld static-group ipv6-group-address [ source ipv6-source-address ]
undo mld static-group { all | ipv6-group-address [ source ipv6-source-address ] }
View
Interface view
Default level
2: System level
Parameters
ipv6-group-address: Specifies an IPv6 multicast group address, in the range of FFxy::/16 (excluding
FFx0::/16, FFx1::/16, FFx2::/16, and FF0y::), where x and y represent any hexadecimal number
ranging from 0 to F.
ipv6-source-address: IPv6 address of the specified multicast source.
all: Removes all static IPv6 multicast groups that the current interface has joined.
Description
Use mld static-group to configure the current interface to be a statically-connected member of the
specified IPv6 multicast group or IPv6 multicast source and group.
Use undo mld static-group to remove the configuration.
By default, an interface is not a statically-connected member of any IPv6 multicast group or IPv6 multicast
source and group.
If the IPv6 multicast address is in the SSM multicast address range, you must specify an IPv6 multicast
source address at the same time. Otherwise MLD routing table entries cannot be established. No such a
restriction exists if the specified IPv6 multicast group address is not in the SSM multicast address range.
340