HP 3600 v2 Series Command Reference Manual page 230

Field
BGP last state
Port
Configured: Active Hold Time: 180 sec
Keepalive Time: 60 sec
Received: Active Hold Time
Negotiated: Active Hold Time Keepalive
Time:60 sec
Peer optional capabilities
Peer support bgp multi-protocol extended
Peer support bgp route refresh capability
Peer support bgp route AS4 capability
Address family IPv4 Unicast
Received
Sent
Maximum allowed prefix number
Threshold
Minimum time between advertisement runs
Optional capabilities
Route refresh capability has been enabled
ORF advertise capability based on prefix (type
64):
Local: both
Negotiated: send
Peer Preferred Value
Description
Previous state of the peer.
TCP port numbers.
Local holdtime interval and keepalive interval.
Remote holdtime interval.
Negotiated holdtime interval and keepalive interval.
Optional capabilities that the peer supports, including
multiprotocol BGP extensions and route refresh.
The peer supports multiprotocol BGP extensions.
The peer supports route refresh.
The peer supports 4-byte router IDs.
Routes are advertised and received in IPv4 unicasts.
Total numbers of received packets and updates.
Total numbers of sent packets and updates.
Maximum allowed prefix number.
Threshold value.
Minimum route advertisement interval.
Optional capabilities that the peer enables (displayed only
after optional capabilities are configured).
The route-refresh capability has been enabled.
The BGP peer supports the ORF capability based on IP
prefix. The capability value is 64. (This field is displayed
only after the ORF capability is enabled for the BGP peer.)
The local BGP router supports both the ORF sending and
receiving capabilities. (This field is displayed only after the
ORF capability is enabled for the BGP peer.)
Negotiation result: The local BGP router can send
route-refresh messages that carry the ORF information, and
the peer can receive route-refresh messages that carry the
ORF information.
•
If receive is displayed, the local BGP router can receive
route-refresh messages that carry the ORF information,
and the peer can send route-refresh messages that carry
the ORF information.
•
If both send and receive are displayed, the local BGP
router and the peer can both send and receive
route-refresh messages that carry the ORF information
•
This field is not displayed if neither the send nor the
receive capability is supported.
•
This field is displayed only after the ORF capability is
enabled for the BGP peer.
Preferred value specified for the routes from the peer.
217