Static-Rp (Pim View) - HP 3600 v2 Series Command Reference Manual

<Sysname> system-view
[Sysname] pim vpn-instance mvpn
[Sysname-pim-mvpn] state-refresh-ttl 45

static-rp (PIM view)

Syntax
static-rp rp-address [ acl-number ] [ preferred ] [ bidir ]
undo static-rp rp-address
View
Public network PIM view, VPN instance PIM view
Default level
2: System level
Parameters
rp-address: Specifies the IP address of the static RP to be configured. This address must be a real, valid
unicast IP address, rather than an address on the 127.0.0.0/8 segment. For a static RP serving BIDIR-PIM,
you can specify a virtual IP address.
acl-number: Specifies a basic ACL number, in the range of 2000 to 2999. If you provide this argument,
the configured static RP provides services for only those groups that pass the ACL filtering. Otherwise, the
configured static RP provides services for the all-system group 224.0.0.0/4.
preferred: Gives priority to the static RP if the static RP conflicts with the dynamic RP. If you do not include
the preferred keyword in your command, the dynamic RP receives priority, and the static RP takes effect
only if no dynamic RP exists in the network or when the dynamic RP fails.
bidir: Configures the static RP to provide services for multicast groups in BIDIR-PIM. Without this argument,
the static RP provides services for groups in PIM-SM.
Description
Use static-rp to configure a static RP.
Use undo static-rp to configure a static RP.
By default, no static RP is configured.
PIM-SM or PIM-DM cannot be enabled on an interface that acts as a static RP.
When the ACL rule applied on a static RP changes, a new RP must be elected for all the multicast groups.
You can configure multiple static RPs by using this command repeatedly. However, if you use this
command multiple times and specify the same static RP address or reference the same ACL rule, the most
recent configuration takes effect. If you have configured multiple static RPs for the same multicast group,
the one with the highest IP address provides services for the multicast group.
You can configure up to 50 static RPs on the same device.
Related commands: auto-rp enable and display pim rp-info.
Examples
# In the public network, configure the interface with the IP address 1 1.1 10.0.6 to be a static RP that
provides services for the multicast groups in the address range of 225.1.1.0/24 defined in ACL 2001, and
give priority to this static RP in the case of static/dynamic RP conflict.
173