C-Rp (Pim View) - HP 3600 v2 Series Command Reference Manual
Ip multicast
Hide thumbs
Also See for 3600 v2 Series:
- Command reference manual (510 pages) ,
- Configuration manual (441 pages) ,
- Security configuration manual (398 pages)
Table of Contents
Advertisement
Related commands: c-bsr, c-bsr global, and c-bsr group.
Examples
# Set the global C-BSR priority to 5 in the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] c-bsr priority 5
# Set the global C-BSR priority to 5 in VPN instance mvpn.
<Sysname> system-view
[Sysname] pim vpn-instance mvpn
[Sysname-pim-mvpn] c-bsr priority 5
c-rp (PIM view)
Syntax
c-rp interface-type interface-number [ group-policy acl-number | priority priority | holdtime hold-interval
| advertisement-interval adv-interval ] * [ bidir ]
undo c-rp interface-type interface-number
View
Public network PIM view, VPN instance PIM view
Default level
2: System level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
acl-number: Specifies a basic ACL number, in the range of 2000 to 2999. This ACL defines a range of
multicast groups to which the C-RP is designated, rather than defining a filtering rule. Any group range
that matches the permit statement in the ACL is advertised as a group to which the RP is designated, but
the configuration that matches other statements, like deny, does not take effect.
priority: Specifies the priority of the C-RP, in the range of 0 to 255. The default is 192. A larger value of
this argument means a lower priority.
hold-interval: Specifies the C-RP timeout time, in seconds. The value ranges from 1 to 65,535. If you do
not provide this argument in your command, the corresponding global setting is used.
adv-interval: Specifies the C-RP-Adv interval in seconds, with an effective range of 1 to 65,535. If you do
not provide this argument in your command, the corresponding global setting is used.
bidir: Configures the C-RP to provide services for multicast groups in BIDIR-PIM. Without this argument,
the C-RP provides services for multicast groups in PIM-SM.
Description
Use c-rp to configure the specified interface as a C-RP.
Use undo c-rp to remove the related C-RP configuration.
No C-RPs are configured by default.
You must enable PIM-SM on the interface that you want to configure as a C-RP.
If you do not specify a group range for the C-RP, the C-RP provides service for all multicast groups.
122
Advertisement
Table of Contents
