Static-Rp (Ipv6 Pim View) - HP 3600 v2 Series Command Reference Manual

View
IPv6 PIM view
Default level
2: System level
Parameters
interval: Time to wait before receiving a new refresh message, in seconds and with an effective range of
1 to 65535.
Description
Use state-refresh-rate-limit to configure the time that the router must wait before it receives a new state
refresh message.
Use undo state-refresh-rate-limit to restore the default.
By default, the device waits 30 seconds before it receives a new state refresh message.
Related commands: pim ipv6 state-refresh-capable, state-refresh-hoplimit, and state-refresh-interval.
Examples
# Configure the device to wait 45 seconds before it receives a new state refresh message.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-rate-limit 45

static-rp (IPv6 PIM view)

Syntax
static-rp ipv6-rp-address [ acl6-number ] [ preferred ] [ bidir ]
undo static-rp ipv6-rp-address
View
IPv6 PIM view
Default level
2: System level
Parameters
ipv6-rp-address: Specifies the IPv6 address of the static RP to be configured. This address must be a real,
valid, globally scoped IPv6 unicast address. For a static RP serving IPv6 BIDIR-PIM, you can specify a
virtual IPv6 address.
acl6-number: Specifies a basic IPv6 ACL number, in the range of 2000 to 2999. If you provide this
argument, the configured static RP provides services for only those IPv6 multicast groups that pass the
filtering. Otherwise, the configured static RP provides services for the all IPv6 multicast groups.
preferred: Gives priority to the static RP if the static RP conflicts with the dynamic RP. If you do not include
the preferred keyword in your command, the dynamic RP receives priority, and the static RP takes effect
only if no dynamic RP exists in the network or when the dynamic RP fails.
bidir: Configures the static RP to provide services for multicast groups in IPv6 BIDIR-PIM. Without this
argument, the static RP provides services for groups in IPv6 PIM-SM.
403