Multicast Load-Splitting - HP 3600 v2 Series Command Reference Manual

Description
Use multicast forwarding-table route-limit to configure the maximum number of entries in the multicast
forwarding table.
Use undo multicast forwarding-table route-limit to restore the maximum number of entries in the
multicast forwarding table to the default.
By default, the upper limit is 2000.
Related commands: display multicast forwarding-table.
Examples
# Set the maximum number of entries in the multicast forwarding table on the public network to 200.
<Sysname> system-view
[Sysname] multicast forwarding-table route-limit 200
# Set the maximum number of entries in the multicast forwarding table of VPN instance mvpn to 200.
<Sysname> system-view
[Sysname] ip vpn-instance mvpn
[Sysname-vpn-instance-mvpn] multicast forwarding-table route-limit 200

multicast load-splitting

Syntax
multicast load-splitting { source | source-group }
undo multicast load-splitting
View
System view, VPN instance view
Default level
2: System level
Parameters
source: Specifies load splitting on a per-source basis.
source-group: Specifies load splitting both on a per-source basis and a per-group basis.
Description
Use multicast load-splitting to enable load splitting of multicast traffic.
Use undo multicast load-splitting to disable load splitting of multicast traffic.
By default, load splitting of multicast traffic is disabled.
This command does not take effect in BIDIR-PIM.
Examples
# Enable per-source load splitting of multicast traffic on the public network.
<Sysname> system-view
[Sysname] multicast load-splitting source
# Enable per-source load splitting of multicast traffic in VPN instance mvpn.
<Sysname> system-view
[Sysname] ip vpn-instance mvpn
65