Igmp-Snooping Host-Aging-Time - HP 3600 v2 Series Command Reference Manual

If the specified ACL does not exist or the ACL rule is null, all multicast groups are filtered out.
You can configure different ACL rules for a port in different VLANs. For a given VLAN, a newly
configured ACL rule overrides the existing one.
Related commands: group-policy.
Examples
# Apply ACL 2000 as a multicast group filter so that hosts on Ethernet 1/0/1 in VLAN 2 can join
225.1.1.1 only.
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 225.1.1.1 0
[Sysname-acl-basic-2000] quit
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] igmp-snooping group-policy 2000 vlan 2

igmp-snooping host-aging-time

Syntax
igmp-snooping host-aging-time interval
undo igmp-snooping host-aging-time
View
VLAN view
Default level
2: System level
Parameters
interval: Specifies an aging timer in seconds for dynamic member ports. The value ranges from 200 to
1000.
Description
Use igmp-snooping host-aging-time to set the aging timer for dynamic member ports for a VLAN.
Use undo igmp-snooping host-aging-time to restore the default.
By default, the aging time of a dynamic member port is 260 seconds.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands: host-aging-time and igmp-snooping enable.
Examples
# Enable IGMP snooping and set the aging timer for dynamic member ports in VLAN 2 to 300 seconds.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping host-aging-time 300
18