Description
Use pim ipv6 triggered-hello-delay to configure the maximum delay between hello messages.
Use undo pim ipv6 triggered-hello-delay to restore the default.
By default, the maximum delay between hello messages is 5 seconds.
Examples
# Set the maximum delay between hello messages to 3 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim ipv6 triggered-hello-delay 3
probe-interval (IPv6 PIM view)
Syntax
probe-interval interval
undo probe-interval
View
IPv6 PIM view
Default level
2: System level
Parameters
interval: Register probe time in seconds, with an effective range of 1 to 1799.
Description
Use probe-interval to configure the register probe time.
Use undo probe-interval to restore the default.
By default, the register probe time is 5 seconds.
Related commands: register-suppression-timeout.
Examples
# Set the register probe time to 6 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] probe-interval 6
prune delay (IPv6 PIM view)
Syntax
prune delay interval
undo prune delay
View
IPv6 PIM view
395