C-Rp Holdtime (Ipv6 Pim View) - HP 3600 v2 Series Command Reference Manual

Default level
2: System level
Parameters
interval: C-RP-Adv interval in seconds, with an effective range of 1 to 65,535.
Description
Use c-rp advertisement-interval to configure the interval at which C-RP-Adv messages are sent.
Use undo c-rp advertisement-interval to restore the default.
By default, the C-RP-Adv interval is 60 seconds.
Related commands: c-rp.
Examples
# Set the global C-RP-Adv interval to 30 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] c-rp advertisement-interval 30

c-rp holdtime (IPv6 PIM view)

Syntax
c-rp holdtime interval
undo c-rp holdtime
View
IPv6 PIM view
Default level
2: System level
Parameters
interval: C-RP timeout in seconds, with an effective range of 1 to 65,535.
Description
Use c-rp holdtime to configure the global C-RP timeout time, namely, the length of time that the BSR waits
for a C-RP-Adv message from C-RPs.
Use undo c-rp holdtime to restore the default.
By default, the C-RP timeout time is 150 seconds.
Because a non-BSR router refreshes its C-RP timeout time through bootstrap messages, to prevent loss of
C-RP information in bootstrap messages, be sure that the C-RP timeout time is not smaller than the interval
at which the BSR sends bootstrap messages. The recommended C-RP timeout setting is 2.5 times the BS
period or longer.
Related commands: c-bsr interval and c-rp.
Examples
# Set the global C-RP timeout time to 200 seconds.
<Sysname> system-view
[Sysname] pim ipv6
359