Table of Contents
Advertisement
Configuring an IPv6 policy
Creating an IPv6 node
Step
1.
Enter system view.
2.
Create an IPv6 policy
or policy node, and
enter IPv6 policy
node view.
Setting match criteria for an IPv6 node
Step
1.
Enter system view.
2.
Enter IPv6 policy
node view.
3.
Set an ACL match
criterion.
NOTE:
If an ACL match criterion is defined, packets are compared with the ACL rules, and the permit or
deny action and the time range of the specified ACL are ignored. If the specified ACL does not exist,
no packet is matched.
Configuring actions for an IPv6 node
Step
1.
Enter system
view.
2.
Enter IPv6 policy
node view.
3.
Set an IP
precedence.
4.
Set next hops for
permitted IPv6
packets.
5.
Set output
interfaces.
Command
system-view
ipv6 policy-based-route policy-name [ deny |
permit ] node node-number
Command
system-view
ipv6 policy-based-route policy-name [ deny | permit ]
node node-number
if-match acl { ipv6-acl-number | name ipv6-acl-name }
Command
system-view
ipv6 policy-based-route policy-name
[ deny | permit ] node node-number
apply precedence { type | value }
apply next-hop [ vpn-instance
vpn-instance-name ] { ipv6-address
[ direct ] [ track
track-entry-number ] }&<1-2>
apply output-interface { interface-type
interface-number [ track
track-entry-number ] }
496
Remarks
N/A
By default, no IPv6 policy
node is created.
Remarks
N/A
N/A
By default, no ACL
match criterion is set.
Remarks
N/A
N/A
By default, no IP precedence is
specified.
By default, no next hop is specified.
You can specify two next hops for
backup by executing this command
twice.
By default, no output interface is
specified.
Advertisement
Table of Contents
Troubleshooting
