HP 3600 v2 Series Command Reference Manual page 285

undo mld-snooping host-join ipv6-group-address [ source-ip ipv6-source-address ] vlan vlan-id
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default level
2: System level
Parameters
ipv6-group-address: Specifies the address of the IPv6 multicast group that the simulated host will join. The
value ranges from FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::), where x and y
represent any hexadecimal number between 0 and F, inclusive.
ipv6-source-address: Specifies the address of the IPv6 multicast source that the simulated host will join.
vlan vlan-id: Specifies a VLAN that comprises the port or ports, where vlan-id is in the range of 1 to
4094.
Description
Use mld-snooping host-join to enable simulated joining on a port. Namely, you configure a port as a
simulated member host for the specified IPv6 multicast group or source and group.
Use undo mld-snooping host-join to remove the simulated member host from the specified IPv6 multicast
group or source and group.
By default, this function is disabled.
For the HP 3600 v2 EI switches, this command takes effect in both MLD snooping-enabled VLANs and
VLANs with MLD enabled on their VLAN interfaces. The version of MLD on the simulated member host
is consistent with the version of MLD snooping that runs in the VLAN or the version of MLD that runs on
the VLAN interface.
For the HP 3600 v2 SI switches, this command takes effect in MLD snooping-enabled VLANs. The version
of MLD on the simulated member host is consistent with the version of MLD snooping that runs in the
VLAN.
The source-ip ipv6-source-address option in the command is meaningful only for MLDv2 snooping. If
MLDv1 snooping is running, the source-ip ipv6-source-address option does not take effect although you
can include source-ip ipv6-source-address in the command.
In Layer 2 Ethernet interface view or Layer 2 aggregate interface view, this command takes effect only if
the interface belongs to the specified VLAN. In port group view, this command takes effect only on those
ports in this port group that belong to the specified VLAN.
Examples
# Configure Ethernet 1/0/1 in VLAN 2 to join (2002::22, FF3E::101) as a simulated host.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping version 2
[Sysname-vlan2] quit
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] mld-snooping host-join ff3e::101 source-ip 2002::22 vlan 2
272