Ethernet Switch Self-Test Errors - GE L60 Instruction Manual

Line phase comparison system, ur series
Hide thumbs Also See for L60:
Table of Contents

Advertisement

3.4 MANAGED ETHERNET SWITCH MODULES
The switch will automatically reboot after a successful firmware file transfer.
NOTE
5.
Once the firmware has been successfully uploaded to the switch module, load the settings file using the procedure
described earlier.
The following table provides details about Ethernet module self-test errors.
Be sure to enable the
and the relevant
PORT 1 EVENTS
menu.
ETHERNET SWITCH
3
Table 3–7: ETHERNET SWITCH SELF-TEST ERRORS
ACTIVATION SETTING (SET
AS ENABLED)
ETHERNET SWITCH FAIL
PORT 1 EVENTS to PORT 6
EVENTS
No setting required; the L60
will read the state of a general
purpose input/output port on
the main CPU upon power-up
and create the error if there is a
conflict between the input/
output state and the order
code.
3-56
setting in the
ETHERNET SWITCH FAIL
through
PORT 6 EVENTS
EVENT NAME
ETHERNET MODULE
OFFLINE
ETHERNET PORT 1
OFFLINE to ETHERNET
PORT 6 OFFLINE
EQUIPMENT
MISMATCH: Card XXX
Missing
L60 Line Phase Comparison System

3.4.7 ETHERNET SWITCH SELF-TEST ERRORS


PRODUCT SETUP
USER-PROGRAMMABLE SELF-TESTS
settings under the
PRODUCT SETUP
EVENT CAUSE
No response has been
received from the Ethernet
module after five successive
polling attempts.
An active Ethernet port has
returned a FAILED status.
The L60 has not detected the
presence of the Ethernet
switch via the bus board.
3 HARDWARE

COMMUNICATIONS
POSSIBLE CAUSES
• Loss of switch power.
• IP/gateway/subnet.
• Incompatibility between the CPU and
the switch module.
• UR port (port 7) configured incorrectly
or blocked
• Switch IP address assigned to another
device in the same network.
• Ethernet connection broken.
• An inactive port's events have been
enabled.
The L60 failed to see the switch module
on power-up, because switch won't
power up or is still powering up. To clear
the fault, cycle power to the L60.
GE Multilin
menu


Advertisement

Table of Contents
loading

Table of Contents