GE L60 Instruction Manual page 161

Line phase comparison system, ur series
Hide thumbs Also See for L60:
Table of Contents

Advertisement

5 SETTINGS
PATH: SETTINGS
PRODUCT SETUP
TRANSMISSION
 TRANSMISSION
MESSAGE
MESSAGE
MESSAGE
The general transmission settings are shown below:
PATH: SETTINGS
PRODUCT SETUP
TRANSMISSION
GENERAL
 GENERAL
The
DEFAULT GSSE/GOOSE UPDATE TIME
put state changes to be sent. When remote output data changes, GSSE or GOOSE messages are sent immediately. This
setting controls the steady-state heartbeat time interval.
The
DEFAULT GSSE/GOOSE UPDATE TIME
The GSSE settings are shown below:
PATH: SETTINGS
PRODUCT SETUP

TRANSMISSION
GSEE
 GSSE
MESSAGE
MESSAGE
These settings are applicable to GSSE only. If the fixed GOOSE function is enabled, GSSE messages are not transmitted.
The
setting represents the IEC 61850 GSSE application ID name string sent as part of each GSSE message. This
GSSE ID
string identifies the GSSE message to the receiving device. In L60 releases previous to 5.0x, this name string was repre-
sented by the
setting.
RELAY NAME
GE Multilin


COMMUNICATIONS
IEC 61850 PROTOCOL
 GENERAL
 GSSE
 FIXED GOOSE
 CONFIGURABLE
 GOOSE


COMMUNICATIONS
IEC 61850 PROTOCOL
DEFAULT GSSE/GOOSE
UPDATE TIME: 60 s
sets the time between GSSE or GOOSE messages when there are no remote out-
setting is applicable to GSSE, fixed L60 GOOSE, and configurable GOOSE.


COMMUNICATIONS
IEC 61850 PROTOCOL
GSSE FUNCTION:
Enabled
GSSE ID:
GSSEOut
DESTINATION MAC:
000000000000
L60 Line Phase Comparison System
5.2 PRODUCT SETUP
GSSE/GOOSE CONFIGURATION
GSSE/GOOSE CONFIGURATION
Range: 1 to 60 s in steps of 1
GSSE/GOOSE CONFIGURATION
Range: Enabled, Disabled
Range: 65-character ASCII string
Range: standard MAC address
5
5-23

Advertisement

Table of Contents
loading

Table of Contents