Direct Devices Status; Iec 61850 Goose Integers; Teleprotection Channel Tests - GE L60 Instruction Manual

Line phase comparison system, ur series
Hide thumbs Also See for L60:
Table of Contents

Advertisement

6.2 STATUS
PATH: ACTUAL VALUES
 DIRECT DEVICES
 STATUS
These actual values represent the state of direct devices 1 through 16.

PATH: SETTINGS
INPUTS/OUTPUTS
 GOOSE UINTEGER
 INPUT 1
The IEC 61850 GOOSE uinteger inputs feature allows the transmission of FlexInteger™ values between any two UR-
series devices. The following settings are available for each GOOSE uinteger input.
UINTEGER 1 DEFAULT: This setting specifies the value of the GOOSE uinteger input when the sending device is
offline and the
UINTEGER 1 DEFAULT MODE
number.
UINTEGER 1 DEFAULT MODE: When the sending device is offline and this setting is "Last Known", the value of the
6
GOOSE uinteger input remains at the last received value. When the sending device is offline and this setting value is
"Default Value", then the value of the GOOSE uinteger input is defined by the
The GOOSE integer input FlexInteger™ values are available for use in other L60 functions that use FlexInteger™ values.
PATH: ACTUAL VALUES
 TELEPROT CH TESTS
The status information for two channels is shown here.
CHANNEL 1 STATUS: This represents the receiver status of each channel. If the value is "OK", teleprotection is
enabled and data is being received from the remote terminal; If the value is "FAIL", teleprotection enabled and data is
not being received from the remote terminal. If "n/a", teleprotection is disabled.
6-8

STATUS

DIRECT DEVICES STATUS

DIRECT DEVICE 1
STATUS: Offline
DIRECT DEVICE 2
MESSAGE
STATUS: Offline
DIRECT DEVICE 16
MESSAGE
STATUS: Offline

IEC 61850 GOOSE UINTEGERS
UINTEGER
1000
UINTEGER
MESSAGE
MODE: Default Value
is set to "Default Value".This setting is stored as a 32-bit unsigned integer

STATUS
TELEPROT CH TESTS
CHANNEL 1
STATUS: n/a
CHANNEL 1 LOST
MESSAGE
PACKETS:
CHANNEL 2
MESSAGE
STATUS: n/a
CHANNEL 2 LOST
MESSAGE
PACKETS:
VALIDITY OF CHANNEL
MESSAGE
CONFIGURATION: FAIL
L60 Line Phase Comparison System
Range: Offline, Online
Range: Offline, Online
Range: Offline, Online

6.2.16 IEC 61850 GOOSE INTEGERS


GOOSE UINTEGER INPUT 1(16)
Range: 0 to 429496295 in steps of 1
1 DEFAULT:
Range: Default Value, Last Known
1 DEFAULT
UINTEGER 1 DEFAULT

6.2.17 TELEPROTECTION CHANNEL TESTS

Range: n/a, FAIL, OK
Range: 1 to 65535 in steps of 1
1
Range: n/a, FAIL, OK
Range: 1 to 65535 in steps of 1
1
Range: n/a, FAIL, OK
6 ACTUAL VALUES
6.2.15 DIRECT DEVICES STATUS
setting.
GE Multilin

Advertisement

Table of Contents
loading

Table of Contents