Using The Relay; Faceplate Keypad; Menu Navigation; Menu Hierarchy - GE L60 Instruction Manual

Line phase comparison system, ur series
Hide thumbs Also See for L60:
Table of Contents

Advertisement

1.5 USING THE RELAY

1.5USING THE RELAY
1
Display messages are organized into pages under the following headings: actual values, settings, commands, and targets.
The MENU key navigates through these pages. Each heading page is broken down further into logical subgroups.
The MESSAGE keys navigate through the subgroups. The VALUE keys scroll increment or decrement numerical setting
values when in programming mode. These keys also scroll through alphanumeric values in the text edit mode. Alterna-
tively, values may also be entered with the numeric keypad.
The decimal key initiates and advance to the next character in text edit mode or enters a decimal point. The HELP key may
be pressed at any time for context sensitive help messages. The ENTER key stores altered setting values.
Press the MENU key to select the desired header display page (top-level menu). The header title appears momentarily fol-
lowed by a header display page menu item. Each press of the MENU key advances through the following main heading
pages:
Actual values.
Settings.
Commands.
Targets.
User displays (when enabled).
The setting and actual value messages are arranged hierarchically. The header display pages are indicated by double
scroll bar characters (), while sub-header pages are indicated by single scroll bar characters (). The header display
pages represent the highest level of the hierarchy and the sub-header display pages fall below this level. The MESSAGE
UP and DOWN keys move within a group of headers, sub-headers, setting values, or actual values. Continually pressing
the MESSAGE RIGHT key from a header display displays specific information for the header category. Conversely, contin-
ually pressing the MESSAGE LEFT key from a setting value or actual value display returns to the header display.
HIGHEST LEVEL
 SETTINGS
 PRODUCT SETUP
 SETTINGS
 SYSTEM SETUP
The relay is defaulted to the "Not Programmed" state when it leaves the factory. This safeguards against the installation of
a relay whose settings have not been entered. When powered up successfully, the Trouble LED will be on and the In Ser-
vice LED off. The relay in the "Not Programmed" state will block signaling of any output relay. These conditions will remain
until the relay is explicitly put in the "Programmed" state.
Select the menu message
RELAY SETTINGS:
Not Programmed
1-18
 SECURITY
SETTINGS
PRODUCT SETUP
L60 Line Phase Comparison System
LOWEST LEVEL (SETTING
VALUE)
ACCESS LEVEL:
Restricted

INSTALLATION
RELAY SETTINGS
1 GETTING STARTED

1.5.1 FACEPLATE KEYPAD

1.5.2 MENU NAVIGATION

1.5.3 MENU HIERARCHY

1.5.4 RELAY ACTIVATION

GE Multilin

Advertisement

Table of Contents
loading

Table of Contents