GE L60 Instruction Manual page 100

Line phase comparison system, ur series
Hide thumbs Also See for L60:
Table of Contents

Advertisement

3.4 MANAGED ETHERNET SWITCH MODULES
b) CONFIGURING LAN COMMUNICATIONS
The following procedure describes how to initially configure the Ethernet switch to work on your LAN.
1.
Initiate communications from a PC to the L60 through a front panel serial connection (refer to the Configuring serial
communications section in chapter 1 for details), or if you are familiar with the UR keypad you can use it to set up the
network IP address and check the Modbus slave address and Modbus TCP port.
3
2.
Ensure that the PC and the L60 are on the same IP network.
If your computer is on another network or has a dynamic IP address assigned upon a network login, then setup your
own IP address as follows
2.1.
From the Windows Start Menu, select the Settings > Network Connections menu item.
2.2.
Right-click on the Local Area Connection icon and select the Properties item. This will open the LAN proper-
ties window.
2.3.
Click the Properties button as shown below.
3-48
L60 Line Phase Comparison System
3 HARDWARE
GE Multilin

Advertisement

Table of Contents
loading

Table of Contents