C.3 SERVER FEATURES AND CONFIGURATION
C.3SERVER FEATURES AND CONFIGURATION
IEC 61850 buffered and unbuffered reporting is provided in the GGIO1 logical nodes (for binary status values) and MMXU1
to MMXU6 (for analog measured values). Report settings can be configured using the EnerVista UR Setup software, sub-
station configurator software, or via an IEC 61850 client. The following items can be configured:
TrgOps: Trigger options. The following bits are supported by the L60:
Bit 1: data-change
Bit 4: integrity
Bit 5: general interrogation
OptFlds: Option Fields. The following bits are supported by the L60:
Bit 1: sequence-number
Bit 2: report-time-stamp
Bit 3: reason-for-inclusion
Bit 4: data-set-name
Bit 5: data-reference
Bit 6: buffer-overflow (for buffered reports only)
Bit 7: entryID (for buffered reports only)
Bit 8: conf-revision
Bit 9: segmentation
IntgPd: Integrity period.
BufTm: Buffer time.
MMS file services are supported to allow transfer of oscillography, event record, or other files from a L60 relay.
The timestamp values associated with all IEC 61850 data items represent the time of the last change of either the value or
quality flags of the data item. To accomplish this functionality, all IEC 61850 data items must be regularly scanned for data
changes, and the timestamp updated when a change is detected, regardless of the connection status of any IEC 61850 cli-
ents. For applications where there is no IEC 61850 client in use, the IEC 61850
grammed as "Disabled". If a client is in use, this setting should be programmed as "Enabled" to ensure the proper
generation of IEC 61850 timestamps.
The logical device name is used to identify the IEC 61850 logical device that exists within the L60. This name is composed
of two parts: the IED name setting and the logical device instance. The complete logical device name is the combination of
the two character strings programmed in the
Name" and "LDInst". These values should be changed to reflect a logical naming convention for all IEC 61850 logical
devices in the system.
The LPHD1 logical node contains a data attribute called location (LPHD1.DC.PhyNam.location). This is a character string
meant to describe the physical location of the L60. This attribute is programmed through the
default value is "Location". This value should be changed to describe the actual physical location of the L60.
settings. The default values for these strings are "IED-
L60 Line Phase Comparison System
C.3.1 BUFFERED/UNBUFFERED REPORTING
C.3.2 FILE TRANSFER
C.3.3 TIMESTAMPS AND SCANNING
C.3.4 LOGICAL DEVICE NAME
setting can be pro-
setting and its