GE L60 Instruction Manual page 172

5.2 PRODUCT SETUP
The breaker configuration settings are shown below. Changes to these values will not take effect until the UR is restarted:

PATH: SETTINGS PRODUCT SETUP
 XCBR
 CONFIGURATION
5
The
CLEAR XCBR1 OpCnt
XCBR operating counter status attribute (OpCnt) increments with every operation. Frequent breaker operation may result
in very large OpCnt values over time. This setting allows the OpCnt to be reset to "0" for XCBR1.
5-34

COMMUNICATIONS
XCBR1 ST.LOC OPERAND
Off
XCBR2 ST.LOC OPERAND
MESSAGE
Off
XCBR3 ST.LOC OPERAND
MESSAGE
Off
XCBR6 ST.LOC OPERAND
MESSAGE
Off
CLEAR XCBR1 OpCnt:
MESSAGE
No
CLEAR XCBR2 OpCnt:
MESSAGE
No
CLEAR XCBR3 OpCnt:
MESSAGE
No
CLEAR XCBR6 OpCnt:
MESSAGE
No
setting represents the breaker operating counter. As breakers operate by opening and closing, the
L60 Line Phase Comparison System
 
IEC 61850 PROTOCOL
Range: FlexLogic™ operand
Range: FlexLogic™ operand
Range: FlexLogic™ operand
↓
Range: FlexLogic™ operand
Range: No, Yes
Range: No, Yes
Range: No, Yes
↓
Range: No, Yes
5 SETTINGS
XCBR CONFIGURATION
GE Multilin