Tool Change - Siemens SINUMERIK 802D sl Programming And Operating Manual

5.2.6

Tool change

Functionality
A basic differentiation must be made between a manual and an automatic tool-changer
system.
For an automatic system, the tool change is controlled by the PLC user program. The
currently loaded tool is displayed in the "Manual Machine Plus" main screen.
For a manual system, the required tool number is manually entered from an input screen
form.
Figure 5-5
Operating sequences
Follow the sequence of operations below to enter the required tool number:
1. Move the cursor onto the input field for the T value.
2. Enter the tool number using the numeric keys
3. Accept the tool number by pressing the <INPUT> key.
Manual Machine Plus Turning
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
5.2 Display and operator control optios in the main screen for "Manual Machine Plus"
Extract from main screen "Manual Machine Plus", entry of tool number
(the tool you wish to select must be set up in the tool list!).
The following information text with the corresponding tool number is displayed:
Figure 5-6 Tool change with NC Start
Acknowledge this information text using the "Cancel" softkey.
Manual machining
41