Mirroring-Group Remote-Probe Vlan - HP 6125XLG Command Reference Manual

This operation may delete all settings made on the interface. Continue? [Y/N]:y
# Create remote source group 2, and configure port Ten-GigabitEthernet 1/1/6 as its reflector port in
interface view.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
[Sysname] interface ten-gigabitethernet 1/1/6
[Sysname-Ten-GigabitEthernet1/1/6] mirroring-group 2 reflector-port
This operation may delete all settings made on the interface. Continue? [Y/N]:y
Related commands
mirroring-group

mirroring-group remote-probe vlan

Use mirroring-group remote-probe vlan to specify a VLAN as the remote probe VLAN for a mirroring
group.
Use undo mirroring-group remote-probe vlan to remove a remote probe VLAN from a mirroring group.
Syntax
mirroring-group group-id remote-probe vlan vlan-id
undo mirroring-group group-id remote-probe vlan vlan-id
Default
No remote probe VLAN is configured for a mirroring group.
Views
System view
Predefined user roles
network-admin
Parameters
group-id: Number of the mirroring group, in the range of 1 to 4. The mirroring group specified by
group-id must already exist.
vlan-id: Specifies a VLAN by its ID.
Usage guidelines
You can configure a remote probe VLAN only for a remote source group or remote destination group but
not for a local mirroring group.
When a VLAN is configured as a remote probe VLAN, use the remote probe VLAN for port mirroring
exclusively.
The remote mirroring groups on the source device and destination device must use the same remote
probe VLAN.
Only a static VLAN that already exists can be configured as a remote probe VLAN. A VLAN can be
configured as the remote probe VLAN for only one mirroring group.
To delete a VLAN that is configured as a remote probe VLAN, remove the remote probe VLAN
configuration first.
197