Configuring Gts - HP 5830 Series Configuration Manual

Step
4. Return to system view.
5. Create a behavior and
enter behavior view.
6. Configure a traffic
policing action.
7. Return to system view.
8. Create a policy and enter
policy view.
9. Associate the class with
the traffic behavior in the
QoS policy.
10. Return to system view.
11. Apply the QoS policy.

Configuring GTS

The device supports queue-based GTS, which shapes traffic of a specific queue.
The 5830 Switch Series supports the following types of GTS:
Queue-based GTS—Shapes traffic of a specific queue.
•
• GTS applicable to all traffic—Shapes all traffic.
NOTE:
The HP 5830AF-48G and HP 5830AF-48G TAA support the two types of GTS mentioned above. The HP
5830AF-96G and HP 5830AF-96G TAA support only GTS applicable to all traffic.
Configuring queue-based GTS
Step
1. Enter system view.
2. Enter interface view.
3. Configure GTS for a
queue.
Command
quit
traffic behavior behavior-name
car cir
committed-information-rate [ cbs
committed-burst-size [ ebs
excess-burst-size ] ] [ pir
peak-information-rate ] [ green
action ] [ yellow action ] [ red
action ]
quit
qos policy policy-name
classifier tcl-name behavior
behavior-name
quit
•
Applying the QoS policy to
an interface
•
Applying the QoS policy to a
VLAN
•
Applying the QoS policy
globally
Command
system-view
interface interface-type interface-number
qos gts queue queue-number cir
committed-information-rate
34
Remarks
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Choose one of the application
destinations as needed.
Remarks
N/A
N/A
N/A