Configuring Gts - HP FlexFabric 5700 series Configuration Manual

Step
6. Configure a traffic
policing action.
7. Return to system view.
8. Create a QoS policy
and enter QoS policy
view.
9. Associate the traffic
class with the traffic
behavior in the QoS
policy.
10. Return to system view.
11. Apply the QoS policy.
12. (Optional.) Display
traffic policing
configuration.

Configuring GTS

The switch supports configuring queue-based GTS by using the non-MQC approach. In queue-based
GTS, you set GTS parameters for packets of a queue.
To configure GTS:
Step
1. Enter system view.
2. Enter Ethernet
interface view.
3. Configure GTS for a
queue.
Command
car cir committed-information-rate [ cbs
committed-burst-size [ ebs
excess-burst-size ] ] [ green action | red
action | yellow action ] *
car cir committed-information-rate [ cbs
committed-burst-size ] pir
peak-information-rate [ ebs
excess-burst-size ] [ green action | red
action | yellow action ] *
quit
qos policy policy-name
classifier classifier-name behavior
behavior-name [ insert-before
before-classifier-name ]
quit
•
Applying the QoS policy to an
interface
•
Applying the QoS policy to a VLAN
•
Applying the QoS policy globally
•
Applying the QoS policy to a
control plane
•
Applying the QoS policy to a user
profile
display traffic behavior user-defined
[ behavior-name ]
Command
system-view
interface interface-type interface-number
qos gts queue queue-id cir
committed-information-rate [ cbs
committed-burst-size ]
41
Remarks
Use either of the commands.
By default, no traffic policing action is
configured.
N/A
By default, no QoS policy is
configured.
By default, a traffic class is not
associated with a traffic behavior.
N/A
Choose one of the application
destinations as needed.
By default, no QoS policy is applied.
Available in any view.
Remarks
N/A
N/A
By default, GTS is not configured
on an interface.