Product Safety Information - Magnetek Impulse G+ series 4 Instruction Manual

©2017 MAGNETEK
All rights reserved. This notice applies to all copyrighted materials included with this product,
including, but not limited to, this manual and software embodied within the product. This manual is
intended for the sole use of the persons to whom it was provided, and any unauthorized distribution
of the manual or dispersal of its contents is strictly forbidden. This manual may not be reproduced in
whole or in part by any means whatsoever without the expressed written permission of Magnetek.
Parts of this product may be covered by one or more of the following patents: 6,598,859, 6,653,804,
6,956,339, 7,190,146, 7,841,583, 8,401,814, 8,669,724, and 8,686,670.

Product Safety Information

Magnetek, Inc. (Magnetek) offers a broad range of radio remote control products, control products
and adjustable frequency drives, and industrial braking systems for material handling applications.
This manual has been prepared by Magnetek to provide information and recommendations for the
installation, use, operation and service of Magnetek's material handling products and systems
(Magnetek Products). Anyone who uses, operates, maintains, services, installs or owns Magnetek
Products should know, understand and follow the instructions and safety recommendations in this
manual for Magnetek Products.
The recommendations in this manual do not take precedence over any of the following requirements
relating to cranes, hoists lifting devices or other material handling equipment which use or include
Magnetek Products:
• Instructions, manuals, and safety warnings of the manufacturers of the equipment where the
Magnetek Products are used,
• Plant safety rules and procedures of the employers and the owners of the facilities where the
Magnetek Products are being used,
• Regulations issued by the Occupational Health and Safety Administration (OSHA),
• Applicable local, state or federal codes, ordinances, standards and requirements, or
• Safety standards and practices for the industries in which Magnetek Products are used.
This manual does not include or address the specific instructions and safety warnings of these
manufacturers or any of the other requirements listed above. It is the responsibility of the owners,
users and operators of the Magnetek Products to know, understand and follow all of these
requirements. It is the responsibility of the employer to make its employees aware of all of the above
listed requirements and to make certain that all operators are properly trained. No one should use
Magnetek Products prior to becoming familiar with and being trained in these requirements
and the instructions and safety recommendations for this manual.
Product Warranty Information
Magnetek, hereafter referred to as Company, assumes no responsibility for improper programming
of a drive by untrained personnel. A drive should only be programmed by a trained technician who
has read and understands the contents of this manual. Improper programming of a drive can lead to
unexpected, undesirable, or unsafe operation or performance of the drive. This may result in
damage to equipment or personal injury. Company shall not be liable for economic loss, property
damage, or other consequential damages or physical injury sustained by the purchaser or by any
third party as a result of such programming. Company neither assumes nor authorizes any other
person to assume for Company any other liability in connection with the sale or use of this product.
For information on Magnetek's product warranties by product type, please visit
www.magnetekmh.com.
IMPULSE®•G+ & VG+ Series 4 Instruction Manual - February 2017
i