Inching Control - Magnetek Impulse G+ series 4 Instruction Manual

Inching Control

Inching Control Function can be enabled by programming H01-01–08 = 17, 18, and 19, respectively.
The frequency reference used during inching is determined by B01-17 (Jog Reference).
A directional input is not needed to enable motor torque.
Parameter Display
C13-01 Inch Run Time
C13-02 Repeat Delay Tim
Table 5-42: Inching Control Parameter Settings
Function
Inching Control run time.
Inching Control repeat delay time.
Figure 5-16: Inching Function and Inching Repeat
IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 2017
C A U T I O N
Range
0.00–2.55 sec 1.00
0.00–2.55 sec 1.00
Default Model
G+/VG+
G+/VG+
5-51