Quick Stop - Magnetek Impulse G+ series 4 Instruction Manual

Quick Stop™

The Quick Stop Function provides an automatic Alternate Deceleration at Stop.
NOTE: The Quick Stop Deceleration time differs from the normal deceleration time and is applied
only when the RUN command is removed.
Parameter
C01-01*
C01-02
* Initial value is determined by X-Press Programming (Table 4-6, 4-7, or 4-8 on pages 4-12, 4-13, and 4-14).
IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 2017
5-16
Table 5-15: Quick Stop Parameter Settings
Display Function
Quick Stop Determines whether Quick Stop is
enabled
0 Disabled
1 Enabled
Quick Stop Time Deceleration time during Quick
Stop function.
Figure 5-7: Quick Stop
Range Default
0, 1 0
0.0–25.5 sec 1.0