Sequence/Reference Source - Magnetek Impulse G+ series 4 Instruction Manual

Sequence/Reference Source

B03-01 and B03-02 determine the source from where the frequency reference and RUN command
are generated.
Parameter
B03-01
B03-02
* Initial value is determined by X-Press Programming (Table 4-6, 4-7, or 4-8 on pages 4-12, 4-13, and 4-14).
IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 2017
5-6
Table 5-4: Sequence/Reference Source Parameter Settings
Display Function
Ref Source 1 Source from where the frequency
reference is generated.
0 Operator Digital Operator
1 Terminals Terminals or Analog Input
•
•
•
•
2 Serial Com Serial communication
•
3 Option PCB Industrial Communication Option
card (Port CN5-A)
•
•
•
•
4 Pulse Input Pulse input via Terminal RP(H06-
01)
Run Source 1 Source from where the RUN
command is generated.
0 Operator Digital Operator
1 Terminals Terminals
•
•
•
•
2 Serial Com Serial communication
•
3 Option PCB Industrial Communication Option
card (Port CN5-A)
•
•
•
•
S4-IF Interface Card
S4-I AC Digital Input Option
S4-IO Digital Input/Output Option
DI-A3 Digital Input Option (not used for
B03-02)
RS485/422 Serial Communications
(R+, R-, S+, S-)
EtherNet/IP
Modbus TCP/IP
PROFINET
PROFIBUS-DP
S4-IF Interface Card
S4-I AC Digital Input Option
S4-IO Digital Input/Output Option
DI-A3 Digital Input Option (not used for
B03-02)
RS485/422 Serial Communications
(R+, R-, S+, S-)
EtherNet/IP
Modbus TCP/IP
PROFINET
PROFIBUS-DP
Range Default
0-4 1*
0-3 1*