Terminal Parameters; Digital Inputs - Magnetek Impulse G+ series 4 Instruction Manual

Terminal Parameters

• H1 Digital Inputs
• H2 Digital Outputs
• H3 Analog Inputs
• H4 Analog Outputs
• H5 Serial Communication Set-up
• H6 Pulse Input/Output

Digital Inputs

The IMPULSE
numerous functions. The following table lists the function selections for the multi-function digital
inputs (terminals S1 to S8) and indicates the control methods during which each function can be
enabled. An OPE03 error will occur if a function is programmed in more than one terminal at the
same time.
Parameter
H01-01
H01-02
H01-03
H01-04
H01-05
H01-06
H01-07
H01-08
H01-14
* Initial value is determined by X-Press Programming (Table 4-6, 4-7, or 4-8 on pages 4-12, 4-13, and 4-14).
Table 5-72: Multi-Function Digital Inputs (MFDI) selectable for H01-0x and C09-0x
Display
0 Multi-Step Ref 2
1 Multi-Step Ref 3
2 Multi-Step Ref 4
3 Multi-Step Ref 5
4 Speed Hold 2
5 Accel Command
6 Upper Lmt 1 N.O.
7 Upper Lmt 2 N.O.
8 Lower Lmt 1 N.O.
9 Lower Lmt 2 N.O.
IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 2017
5-86
®
•G+ and VG+ Series 4 has eight multi-function digital inputs for the set-up of
Table 5-71:
Display Function
Term S1 Select Selects the multi-function inputs.
Reference Table 5-72
Term S2 Select Reference Table 5-72
Term S3 Select Reference Table 5-72
Term S4 Select Reference Table 5-72
Term S5 Select Reference Table 5-72
Term S6 Select Reference Table 5-72
Term S7 Select Reference Table 5-72
Term S8 Select Reference Table 5-72
Alt Ref Override Alternate Frequency Reference
Override. When enabled, and an input
0 Disabled
of H01-xx = 1F is true, will switch
between Frequency Reference
1 Enabled
Source 2 (B03-15) and the terminals
(B01-xx).
Function
Multi-Step Reference 2
Multi-Step Reference 3
Multi-Step Reference 4
Multi-Step Reference 5
Speed Hold 2 (2nd Step of Three-Step Infinitely Variable)
Accel Command (2nd Step of Two-Step Infinitely Variable or 3rd Step of
Three-Step Infinitely Variable)
Upper Limit - Slow Down; Normally Open. UL1 - blinking
Upper Limit - Stop; Normally Open. UL2 - blinking
Lower Limit - Slow Down; Normally Open. LL1 - blinking
Lower Limit - Stop; Normally Open. LL2 - blinking
Digital Inputs Parameter Settings
Range Default
0–81 80
(FWD)
0–81 81
(REV)
0–81 *
0–81 *
0–81 *
0–81 *
0–81 *
0–81 *
0, 1 0