Encoder Wiring Diagrams And Information - Magnetek Impulse G+ series 4 Instruction Manual

Encoder Wiring Diagrams and Information

Encoder 1: Install in option port CN5-C
Encoder 2: Install in option port CN5-B.
Table 3-10: Encoder Wiring
Encoder Signal
+5 to 15 VDC
0V
A+
A-
B+
B-
Shield
Table 3-11: PG-X3 Line Driver Encoder Interface Card Specifications
Power supply to encoder:
Encoder input signal:
Pulse monitor output signal (repeater):
Pulse phases accepted:
Maximum input frequency:
NOTE: See PG-B3 Open Collector Encoder Card manual for wiring and terminal descriptions.
Figure 3-17: PG-X3 Encoder Card Wiring
Wire Color
Red
Black
Blue
Gray
Green
Yellow
--
Dual; +5 VDC or +12 VDC; 200 mA maximum
RS-422–level, line-driver-type
RS-422–level, line-driver-type or open collector
Phases A and B (both + and -)
300 kHz
IMPULSE®•G+ & VG+ Series 4 Instruction Manual - February 2017
PG-X3 Terminal
IP
IG
A+
A-
B+
B-
FE
3-25