Profibus-Dp Communication Option Card Set-Up - Magnetek Impulse G+ series 4 Instruction Manual

Profibus-DP Communication Option Card Set-up

Settings for the Profibus-DP communication option card SI-P3.
Parameter
F06-01
F06-02
F06-03
F06-04
F06-06
F06-07
F06-08
F06-30
IMPULSE®•G+ & VG+ Series 4 Instruction Manual – February 2017
5-82
Table 5-69: Communication Option Card Parameter Settings
Display Function
Comm Bus Flt Sel Stopping method at
communication error.
0 Decel to Stop
1 Coast to Stop
2 Fast-Stop
3 Use B3-03 Method
4 Alarm Only
EF0 Detection Option External Fault
0 Always Detected
1 Only During Run
EF0 Fault Action Option External Fault
0 Decel to Stop
1 Coast to Stop
2 Fast-Stop
3 Use B3-03 Method
4 Alarm Only
BUS Err Det Time Set the maximum time the drive
should wait for a communication
error to occur (bUS).
Torq Ref/Lmt Sel Torque Reference Limit Selection
(FLV only)
0 Disabled
1 Enabled
Fref PrioritySel Selects how multi-step speed
inputs are treated when the
NetRef command is set.
0 Net/Com REF Multi-step reference disabled
1 MultiStep Speed Multi-step reference enabled
Com Prm Init Sel Determines whether
communication-related
parameters (F06-xx and F07-xx)
are reset when the drive is
initialized using A01-05
0 Init Com Prms Communication-related
parameters (F06-xx and F07-xx)
are not reset when the drive is
initialized using A01-05.
1 No Init Com Prms Reset all communication-related
parameters (F06-xx and F07-xx)
when the drive is initialized using
A01-05.
PB Node Address Sets the node address if the
Profibus-DP option card is
installed
Range Default
0–4 1
0, 1 0
0–4 1
0.0–5.0 sec 2.0
0, 1 0
0, 1 0
0, 1 0
0–125 0