Debug Ip Verify Source Packet - Cisco Catalyst 4500 Series Configuration Manual
Ios software configuration guide isco ios xe 3.9.0e and ios 15.2(5)ex
Hide thumbs
Also See for Catalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
Chapter 2
Cisco IOS Commands for the Catalyst 4500 Series Switches
debug ip verify source packet
To debug the IP source guard messages, use the debug ip verify source packet command. To disable
the debugging output, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default
Debugging of snooping security packets is disabled.
Command Modes
Privileged EXEC mode
Command History
Release
12.1(12c)EW
Examples
The following example shows how to enable debugging for the IP source guard:
Switch# debug ip verify source packet
Switch#
The following example shows how to disable debugging for the IP source guard:
Switch# no debug ip verify source packet
Switch#
Related Commands
Command
ip dhcp snooping
ip dhcp snooping limit rate
ip dhcp snooping trust
show ip dhcp snooping
show ip dhcp snooping binding
debug ip verify source packet
no debug ip verify source packet
Modification
This command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Description
Globally enables DHCP snooping.
Enables DHCP option 82 data insertion.
Enables DHCP snooping on a trusted VLAN.
Displays the DHCP snooping configuration.
Displays the DHCP snooping binding entries.
debug ip verify source packet
2-165
Advertisement
Table of Contents
