Cisco Catalyst 4500 Series Configuration Manual page 679

Chapter 2
The following example shows how to enable REP on a port and identify the port as the REP secondary
edge port:
Switch (config)# interface GigabitEthernet1/1
Switch (config-if)# rep segment 100 edge
You can verify your settings by entering the show interfaces rep privileged EXEC command. To verify
which port in the segment is the primary edge port, enter the show rep topology privileged EXEC
command.
Related Commands Command
show interfaces rep
[detail]
show rep topology
[detail]
Description
Displays REP configuration and status for all interfaces or the specified
interface.
Displays information about all ports in the segment, including which one was
configured and selected as the primary edge port.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
rep segment
2-639